1
V2002D-PTZ
User’s Manual
Introduction
Refer to the Quick Guide for the V2002D-PTZ for instructions for installing the PTZ dome camera.
Connection
Default IP Address
Since this is a network-based camera, an IP address must be
assigned. The camera’s default IP
address is obtained automatically through a DHCP server in your network; be sure to enable DHCP in
"Network Settings." If DHCP is not available, the camera will use APIPA (link-local address); IPv4 link-
local addresses are assigned from address block 169.254.0.0/16 (169.254.0.0 through 169.254.255.255).
Connecting from a Computer & Viewing Preparation
Connecting from a Computer
Make sure the camera and your computer are in the same subnet.
Check whether the network available between the camera and the computer by executing ping the
default IP address. To do this, simply start a command prompt (Windows: from the “Start Menu”,
select
“Program”. Then select “Accessories” and choose “Command Prompt”), and type “Ping
and then type
your IP address
. If the message “Reply from…” appears, it means the connection is available.
Start a browser e.g., Internet Explorer and enter IP address. A login window as shown below should
pop up. In the window, enter the default user name: ADMIN; it is required to change the password
when you login for the first time for added security
,
which requires at least 8 characters including 1
uppercase letter, 1 special character, alphanumeric characters to log in.
Further administration on the unit can be found in "Configuration."
Figure: Login Window
Summary of Contents for Roughneck Pro V2002D-PTZ
Page 98: ......
