XX091-04-01 Rev 104 AurorAcorD
•
iii
Quick Installation
Warning: Do not connect any unit to a power source until installation is complete.
ALARM
COM1
COM2
LOOPING 2
OUTPUT ONL
Y
12
10
9
11
16
14
13
15
Up to 9
units per
IDL.
V1400X-IDL
V1400X-IDL
Dome
Rcvr.
Pin No.
Signal
Alarm 1-16
Normally open dry contact alarm
Ground
Dry contact alarm common
Normally closed dry contact alarm
1-16
19
20-35
36
37
RS-232/RS-422
Termination Box
(part # 1298-3339-02-00)
RD
BK
OR
BL
W
BR
YL
G
RS-485
Data +
N.C.
Ground
Keyboard
Clock
+5 V Out
Keyboard
Data
N.C.
RS-485
Data–
AurorANet Termination Box
(part # 1298-3339-01-00)
RD
BK
OR
BL
W
BR
YL
G
Ground
Keyboard
Clock
+5 V Out
Keyboard
Data
RS-422
Comm Out –
RS-422
Resp In –
RS-422 Resp In +
or RS-232 RxD
RS-422 Comm Out +
or RS-232 TxD
RS-232/RS-422 Termination Box
(part # 1298-3140-01-00)
NOTE: Internal jumpers and menu settings are set
at the factory for RS-232 on com1 and RS-422 on
com2. These defaults may be changed to use RS-
232, RS-422 or RS-485 (2-wire AurorANet or 4-
wire) on com1 or com2. Menu settings must be
changed as discussed in the Programming chapter
of Instruction Manual XX091. Jumpers may or may
not need to be changed as discussed in the
Reference chapter of Instruction Manual XX091. If
you have not changed the factory default jumper
settings, you can use the AurorANet termination box
on com1 without changing jumpers. Otherwise,
remove appropriate jumpers before using the
AurorANet termination box as discussed in the
Reference chapter of Instruction Manual XX091.
Alarm Devices
VIDEO OUT
Camera
Cable supplied
by installer.
120VAC and 230VAC
cables supplied
in accessory kit.
Total loop resistance
of this cable must be
less than 1 K
Ω
.
Connector and
pins supplied in
accessory kit.
Remote control cable
supplied with AURC-NIU
TO MONITORS
A2K
Video
1/9
A2K
Video
2/10
A2K
Video
3/11
A2K
Video
4/12
A2K
Video
5/13
A2K
Video
6/14
A2K
Video
7/15
A2K
Video
8/16
Terminate with 75 ohms at the destination devices. The Looping 2
connector provides outputs 9-16. Use the "A2K Video" labels for
outputs 9-16. Do not refer to the "Video" label.
Purchased separately
(product code 4476)
SERIAL ETHERNET
DC12V
AURC-NIU
Note: Depending upon your programming choices, the AurorAcorD immediately begins recording to the hard
drive when power is applied.
For 230 VAC units, you must replace the
two 1.25 A fuses with the two 0.63 A
fuses from the accessory kit. Use 1.25 A
fuses for 120 VAC units only
.