VibroSystM DMV-100, Installation Manual

Page: 48 / 52

48 DMV-100 Rotor Creep and Speed Detector - Installation Manual
D
ISPLAY ADJUSTMENT PARAMETERS
Enable/disable comparative set value displays, and set the display refresh periods and position meter.
•
Display refresh period : set to 0.5 (example value)
When the input changes rapidly, the display refresh period can be lengthened to control flickering and
make the display easier to read.
•
Display value selection : set to PV
The display value can be set to the present value, the maximum value, or the minimum value.
•
Automatic Display return : set to 10 seconds (suggested value)
The display automatically returns to RUN level when there are no key operations during setting opera-
tions. The length can be adjusted here.
•
Position meter type : set to incremental (recommended setting)
The meter on the right side of the front panel contains 20 sections to show the position of the displayed
RPM value in relation to set upper and lower RPM limits. The display pattern can be set as follows:
Note : If the position meter lower limit set value is larger than the position meter upper limit set value,
the top and bottom of the above displays will be reversed.
The position meter will not be lit if there is an input error.
The upper and lower limits can be set with the following parameters:
•
Position upper limit : set to 135 (example value)
Set maximum RPM for the scale.
•
Position meter lower limit : set to 0 (example value)
Set minimum RPM for the scale