VibroSystM DMV-100, Installation Manual

Page: 15 / 52

15 DMV-100 Rotor Creep and Speed Detector - Installation Manual
1. Prepare the holes for the cable clamps.
Figure 7 : Preparing holes for the cable clamps
3.2.2 Installation of triaxial extension cable - sensor end
1. On top of the stator, install a length of
protective tubing to protect the triaxial
extension cable and its connection to the
sensor.
Cut the tubing to the right length so that it will
not extend beyond the stator edge. The
tubing can be heated and bent. Install the
tubing in close contact, as much as possible,
with the top of the stator frame.
Figure 8 : Assembly on top of stator frame
Warning - Danger Caution
The protective tubing supplied with the installation kit must be installed on the stator core or
stator frame (ground potential).
(
*
)
* Note: Two ground wires may be present if the sensor cable is
also equipped with a ground wire.