FVAm™ Series Benchtop MPO Autofocus Microscope User Guide
22132675 Rev. 101, Standard, 2-2
Getting started
FVAm microscope features
FVAm microscope features
The FVAm microscope is available with a touchscreen display module (FVAM-1000-S) or without a touchscreen
display module (FVAM-1000). Both models are designed to interface with the FiberChekPRO Automated Fiber
Inspection and Analysis software (see
“Connecting to FiberChekPRO” on page 2-11
); however, the FVAM-1000-S
model features onboard controls to facilitate using the touchscreen to set up and start Pass/Fail tests and then
review test results (see
“Touchscreen display module and onboard controls” on page 2-12
).
Both FVAm microscope models support FMAG adapters (see
“Using FMAG adapters” on page 2-5
), and feature an
Auto Focus/Inspection Trigger
“Auto Focus/Inspection Trigger and microscope LEDs” on
) and a Y-Axis Adjustment dial (see
“Y-axis adjustment” on page 2-17
).
Figure 2-1: FVAm Series Benchtop MPO Autofocus Microscope - FVAM-1000-S
Figure 2-2: FVAm Series Benchtop MPO Autofocus Microscope - rear panel
CAUTION
Power off the device, and disconnect all cables connected to it before moving the device or performing
maintenance procedures.