Network Video Recorder User Manual
Simultaneously press
Ctrl
and
C
to exit the ping command.
Step 26 Verify the frame rate is real-time frame rate.
Select “Menu > Record > Parameters > Record”, and set the Frame rate to Full
Frame.
Step 27 Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our company to do the further process.
Live view stuck when video output remotely via the Internet Explorer or platform
software. Possible Reasons:
−
Poor network between NVR and IP camera, and there exists packet loss during the
transmission.
−
Poor network between NVR and PC, and there exists packet loss during the
transmission.
−
The performances of hardware are not good enough, including CPU, memory, etc..
Step 28 Verify the network between NVR and IP camera is connected.
23)
When image is stuck, connect the RS-232 ports on PC and the rear panel of NVR
with the RS-232 cable.
24)
Open the Super Terminal, and execute the command of “
ping
192.168.0.0
–l 1472
–f
” (the IP address may change according to the real condition), and check if there
exists packet loss.
Simultaneously press
Ctrl
and
C
to exit the ping command. Step 29 Verify the network
between NVR and PC is connected.
1)
Open the cmd window in the Start menu, or you can press
“R” shortcut
key to open it.
2)
Use the ping command to send large packet to the NVR, execute the command
of “ping 192.168.0.0 –l 1472 –f” (the IP address may change according to the
real condition), and check if there exists packet loss.
Simultaneously press
Ctrl
and
C
to exit the ping command.
Step 30 Verify the hardware of the PC is good enough.
Summary of Contents for VZ-NVR-161080-P
Page 1: ...NETWORK VIDEO RECORDER Quick Start Guide...
Page 115: ...Network Video Recorder User Manual Figure 6 19 Interface of External File Playback...
Page 145: ...Network Video Recorder User Manual Figure 8 18 Copy Settings of Alarm Output...
Page 214: ...Network Video Recorder User Manual Figure 13 26 View HDD Status 2...
