VETRON 5000, Service Manual

Page: 38 / 118

1
2
A
B
3
4
36
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
37
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
DISPLAY STEP DESCRIPTION
» ADJUSTMENT OF THE MATERIAL THICKNESS MEASUREMENT SYSTEM
INFO:
During adjustment, please check if the magnet strip support
3
is parallel to the presser foot bar
4
.
01
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
02 » Until chapter 02 appears on the display.
03
2 s
s
M
y etup e t s
a me r u a t e 0
s
m
» Confirm.
INFO: The pedal is blocked.
The sewing feet can be moved
by hand up and down.
04
In the blocked mode the sewing feet can be moved
up and down by hand while checking if the LEDs
A
and
B
are lit in every position.
05
Loosen the screws
1
and move the support
2
into a position in which the LEDs
A
and
B
are
lit in every sewing feet position.
06
Tighten screw
1
.
07
» Confirm to proceed to the next step.
NOTE:
The sensor must have the same distance to the magnetic strip in every position
of the feet.
INFO:
The green and the red LED should be lit in every position.
03. ADJUSTMENT
02. ADJUSTMENT OF THE MATERIAL THICKNESS MEASUREMENT SYSTEM