VETRON 5000, Service Manual

Page: 89 / 118

3
3
2
1
4
5
1 2
3 4
86
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
87
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
04. SHORT THREAD CUTTER
03. THREAD CUTTING TIMING (CONTROL CAM)
DISPLAY STEP DESCRIPTION
» THREAD CUTTING TIMING (CONTROL CAM)
01
Activate the ADJUSTMENT WIZARD
(02.01. / Page 19).
02 » Until chapter 24 appears on the display.
03
4
i
T r
e djust h g a
h ea a ch c d r t 2
h
t
» Confirm.
INFO: Stitch length is set to 0mm ,
pedal is blocked, the display shows the
machine position in degrees.
04
Loosen screws 4 .
05 Turn machine with the mechanical handwheel to the position 333° .
06
Move the roller lever
5
into the cam
3
while turning the cam to reach the position shown in
image 4.
07
Tighten screws
4
while making sure the cam is positioned against the stop on the left side.
08 » Confirm to proceed to the next point.
NOTE:
At top dead center of the take up lever
1
the thread catcher
2
should be in its parking
position. At position 333° the roller of the lever 5 should be positioned as shown in image 4.