VETRON 5000, Service Manual

Page: 66 / 118

2
1
A
3
4
5
1
64
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
65
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
03. ADJUSTMENT
27. THREAD CATCHER RESTING POSITION
DISPLAY STEP DESCRIPTION
» THREAD CATCHER RESTING POSITION
01
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
02 » Until chapter 27 appears on the display.
03
7
s
T r
e o setup t s
h ea a ch c d r t 2
r
p
» Confirm.
INFO: The pedal is blocked. While
turning by hand the display shows the
machine position in degrees. Stitch
length is set to 0mm .
04
Turn the machine by hand so that the thread cutting operation is safely completed.
05
Loosen screw
3
.
06
Move the thread catcher
1
until its point is in
line with the cutting edge of the knife
2
as shown in image 1(
A
).
07
With attention to the secure touching of the roller lever
4
to the control cam
5
, tighten screw
3
.
NOTICE:
Avoid vertical play.
08 » Confirm to proceed to the next step.
NOTE:
In resting position of the thread catcher
1
the cutting edge of the knife
2
should be in line
with the point of the thread catcher
1
(
A
).