VETRON 5000, Service Manual

Page: 100 / 118

2
A
3
4
5 4
1
98
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
99
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
04. SHORT THREAD CUTTER
13. FEED DOG HEIGHT ADJUSTMENT - SHORT CUTTER
NOTE:
The feed dog
1
should be in its highest position 0.8mm above the stitch plate (See 03.16 ).
At bottom dead center the gap between bottom edge feed dog
1
and thread
catcher
2
position
A
should be
0.8mm
(thread size).
DISPLAY STEP DESCRIPTION
» ADJUSTMENT OF THE FEED DOG HEIGHT
01
Activate the
ADJUSTMENT WIZARD
(see 02.01. / Page 19).
02 » Until chapter 24 appears on the display.
03
4
i
T r
e djust h g a
h ea a ch c d r t 2
h
t
» Confirm.
INFO: Stitch length is set to 0mm ,
pedal is blocked, the display shows the
machine position in degrees.
04 Turn the feed dog in its top dead center ( 190° ) with the mechanical handwheel.
05
Loosen screw
3
until the feed dog carrier
2
can be easily moved up and down.
06
Put the gauge
5
on the stitch plate.
07
Press the feed dog carrier
4
with the feed dog upwards until the surface of the feed dog is
touching the gauge
5
.
08
Tighten screw
3
.
09 » Confirm to proceed to the next step.