EUROBLOC
GENERAL OVERHAUL INSTRUCTIONS
28/69
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
09/2016
8.2.1 Rope drum for hoist frame size: VT3
1. Rope drum
2. Needle-bearing strip (bearing band)
3. Bearing housing
4. Connector rod
5. Axial locking part
The rope drum must also be replaced if:
Inspection method:
The wear of the drum bearing running surface is more
than allowed. This means that you should replace the
hoist with a new hoist as it is not cost-efficient to
continue GO service.
Measurement.
See
the
following
instructions:
“Measuring drum bearing running surface wear”.
Drum bearing housing (part 3 in the figure) has sharp
edges that cannot be filed down, or is otherwise
damaged. This means that you should replace the hoist
with a new hoist as it is not cost-efficient to continue GO
service.
Visual.
TO ORDER: a new hoist.
Measuring drum bearing running surface wear
Clean the bearing running surface before you start measuring wear.