47
B City Water Fill See Figure 1
Water may be received into the system through a
direct hook-up referred to as “CITY WATER FILL”.
After attaching a supply hose to the hook-up, open
the faucet from supply line. Enter coach and open all
faucets to relieve air from the lines. The water heater
(if so equipped) will fill first. You will experience some
air pockets. Allow them to escape before closing the
faucets.
Instructions to utilize system #1.
T=Water Storage Tank.
S=Siphon hose, used to :
(a) Winterize water system.
(b) Sanitize water system.
P=Pump,12V, DC—To supply coach
with water when city water is not
available.
F=Filter–Cap to be removed to
cleanout or replace.
G=Gravity water fill—To fill water tank.
C=City water fill—to fill all lines.
V1= Valve to be opened ONLY when using siphon hose.
V2= Valve to be open to draw water from supply tank. Must be
closed when siphon hose is used.
Filling Fresh Water System—#2
On some models, due to floor plan, there is no standard gravity
water fill for storage tank. Inside of coach, close to pump location, on
floor in a cabinet you will find 3 valves plus the siphon hose. V3
needs to be opened to fill supply
tank, as shown in diagram to the
right.
Follow
instructions
below to
utilize #2 system.
F=Filter– Remove cap to clean or
replace filter.
P=Pump,12V, DC-To supply
water when city water is not
available.
C=City water Fill
S=Siphon hose=To draw liquid-
Antifreeze or sanitize solution.
Figure 1
PDF created with pdfFactory trial version
www.pdffactory.com
