SERVICE
Service - 60
Outer Dual Wheel Removal and Installa-
tion
1.
Raise the power unit approximately 5 cm (2 inch
-
es) by driving the power unit onto wood planks
positioned in line with the inner wheels. The outer
dual wheels should not contact the wood planks.
A jack and jack stands may be used to raise and
support the power unit if planks are not available.
WARNING
Place wheel chocks in front and back of the inner
wheels to prevent the power unit from rolling for-
ward or backward during removal or installation of
the outer dual wheels.
2. Place wheel chocks in front and back of the inner
wheels to prevent accidental movement.
Outer Dual Wheel Removal:
1.
Loosen the draw bolts approximately five turns.
2. With a medium size hammer, hit the end of the
draw bolt until the draw cone releases.
3. Remove the dual wheel assemblies by rotating
them counterclockwise.
4. Install the four plastic plugs from the dual wheel
kit into the inner dual wheel hubs.
5. If desired, move the steering cylinder to the inner
hole setting of the cylinder mount under the left
front corner of the foot platform. Torque to 203
Nm (150 ft-lbs).
Outer Dual Wheel Installation:
1. Remove the plastic plugs from the inner dual
wheel hubs.
2. Inspect the threaded end of the dual wheel exten-
sions to ensure the draw cone, the draw bolt, and
the external threads of the dual wheel extension
have a light coating of grease. Apply grease if
necessary.
3. The draw cone must be loose before installing the
dual wheel extension into the inner hub. Check by
sliding the draw bolt in and out. It should have 6.5
- 13 mm (1/4 - 1/2 inch) of travel.
4. Insert the threaded end of the dual wheel exten-
sion into the inner dual wheel hub. Using both
hands, turn the dual wheel clockwise until the
wheel is tight and there are four threads or fewer
visible on the outer wheel extension. This is to
ensure the hubs lock correctly when the draw bolt
is tightened. Repeat for the other three wheels.
5.
After tightening the outer dual wheel, there should
be four or fewer threads visible on the outer dual
wheel extension.
Tighten the draw bolt and torque to 163 Nm (120
ft-lbs) Repeat for the other three wheels.
6. If the steering cylinder is mounted to the inner
hole setting of the steering cylinder mount, move
the steering cylinder to the center hole setting of
the cylinder mount under the left front corner of
the foot platform. Torque to 203 Nm (150 ft-lbs).
Tire Pressure
Keep tires evenly inflated. Keep tire pressures within
the proper range to prevent premature wear and/or
poor traction.
Tire
Single
Wheel
Dual Wheels
Inner
Outer
All Terrain
55-110 kPa
(8-16 psi)
55-69 kPa
(8-10 psi)
41-55 kPa
(6-8 psi)
Bar
55-110 kPa
(8-16 psi)
55-69 kPa
(8-10 psi)
41-55 kPa
(6-8 psi)
Turf
103-138 kPa
(15-20 psi)
103-117 kPa
(15-17 psi)
69-83 kPa
(10-12 psi)
https://www.tractormanualpdf.info/
