SERVICE
Service - 50
13. Add oil to the engine. Refer to the Engine Owner’s
Manual for proper oil specifications and capacity.
ATTENTION
For optimal engine life and performance, use Ventrac
full synthetic engine oil (Part Number 15.0037-1).
14.
Install the oil fill cap and wipe up any oil spills.
15. Start the power unit and let it run at low idle engine
speed for approximately two to three minutes.
16.
Shut off the engine and remove the ignition key.
17.
Check for leaks around the oil filter. If any leaks
are evident, the filter may need tightened further,
or the filter may need to be removed, the gasket
and filter mount cleaned, and the filter reinstalled.
18. Check the engine oil level after allowing the en-
gine to cool for approximately two minutes and
add oil if necessary.
19. Reinstall the left engine cover.
Changing the Air Filter Elements
ATTENTION
When both air filter elements are removed, an open
-
ing is created to the internal parts of the engine.
Be sure nothing falls into the canister that could
make its way into the engine. Have the new filter
elements ready to install immediately after remov-
ing the old filter elements.
Improper service to the engine air filter can result in
severe engine damage.
•
Inspect the filter daily in extreme heat, dust, or
other severe conditions.
•
Never run the engine without a proper air filter
installed.
•
Never wash or clean the paper filter element.
1. If the power unit has been running, allow the
engine to cool.
2.
A
Release both latches (B) on the engine air filter as
-
sembly (A) and unhook the latches from the main
filter housing.
3.
B
C
D
E
B
Remove the filter cap (C).
4.
Remove and discard the primary (outer) air filter
element (D).
5.
If the safety (inner) air filter element (E) is sched
-
uled for replacement, remove and discard the
safety air filter element.
6.
Install the new air filter element(s).
7.
Reinstall the filter cap and fasten both latches.
https://www.tractormanualpdf.info/
