Vendo VUE 30, User Manual

Page: 117 / 141

Coin Inlet Changer inlet chute
blocked - no coins
sensed for over 96
hours by the changer. Check inlet chute for blockage. Drop coins in
Sales Mode or Tube Fill Mode to test
acceptance. Manually clear the error. Clear inlet chute blockage. If no blockage found,
replace changer. If acceptance rate is acceptable,
system is OK. If acceptance rate is low or changer will
not accept coins, replace changer.
Tube Jam Tube pay out jam --
reported by changer. Check changer tubes and payout for blockage. Clear blockage, if found. If no blockage is found,
replace changer.
If error does not clear, replace changer/acceptor. Coin Read Only
Memory Changer check sum
incorrect -- reported
by changer. Unplug machine, wait at least five seconds,
replug machine. Manually clear the error
Replace acceptor
Check escrow lever and associated
mechanisms. Manually clear the lever and error. Excessive
Escrow Excessive escrow
requests -- more than
255 requests since
the last coin was
sensed.
Close door then reopen. Check to see if error
still occurs. Replace changer/acceptor.
Coin Jam Coin jam - reported
by changer Check changer/acceptor for jammed coins or
other obstructions. If no obstructions are apparent, replace
changer/acceptor
Check changer/acceptor for obstructions or dirt If no obstructions are apparent, and acceptance
appears to be OK, this may be an indication of
cheating attempts.
Low Acceptance Low acceptance rate
-- coin acceptance
has fallen below 80%
Drop coins test acceptance. If no obstructions are apparent and coins do not
accept, or acceptance rate is poor, replace
changer/acceptor.
Accept
Disconnect Disconnected
acceptor -- indicates
that an acceptor is
unplugged. Check coin mechanism plugs. Check for faulty
harness wiring (see wiring diagram for circuit). Correct connections.
Routing Coin routing -
indicates a coin was
routed incorrectly. Verify acceptor set-up using manufacturer's
recommendations. If acceptor was set up correctly, replace acceptor.
Dollar Bill Validator
If changer or card reader is being used, check
for "Coin Communication" or "Coin Read Only
Memory" errors. Bill Validator
Communication Bill validator
communications - No
bill validator
communication for 5
seconds.
Turn off door switch and wait at least five
seconds. Turn on door switch.
If there are no "Coin Communication" or "Coin Read
Only Memory" errors: 1) Check bill acceptor harness;
2) Replace bill acceptor. If there is a "Coin
Communication" or "Coin Read Only Memory" 1)
Check control board MDB harness.
Bill Validator Full Bill validator full -
reported by validator
(STACKER
command).
Insure bill cashbox is empty and that the
cashbox is properly closed and in place. If cashbox appears to be OK, replace bill acceptor.