Vendo VUE 30, User Manual

Page: 123 / 141

PDC movement
on X-Rail is very
slow while going
home in X -
Direction Hand retrieves a
product, the PDC
appears to stop on X-
axis when it is near
the vend drop
position Vend any product, make sure the X-movement
is smooth while the PDC is going to the home
position in X. If the PDC appears to stop then move, change the
rollers in the X-carriage.
Hand stopping at
the middle of the
machine. Hand moves to the
hopper above
position and stops. 1) Check the diagnostic message.
2) Check the hopper flap. 1) Perform action as defined in the error code.
2) Change flap motor if it is not working.
When the PDC is
away from the
'Home' position,
the rail moves
upward in Y-
direction and
stops. The PDC moved in Y
direction but not in Z. Service Mode:Activate PDC Software
Maintainance Make sure the hand assembly is fitted evenly on the
L/R Z- tracks in the 'Hand Housing'.If the hand is off
the tracks - POWER DOWN.Separate the hand
assemly from the housing by rotating the Z-Motor
Encoder Wheel (black wheel visible once hand is
extended). Place the hand assemly evenly back onto
the left and right tracks. POWER ON. Wait during
Discovery.If performing this action does not correct the
problem, change the PDC hand.
The PDC Hand
crashes into the
flap. 1.The Y Motor
Encoder is potentially
malfunctioning.
2.The flap linkage is
broken POWER DOWN
Disconnect the Flap motor.
1) POWER ON while the hand is away from
the home position.
2. Perform the flap test. Check that the position of the hand is around the
middle of the vend flap when it is in the vend drop
mode.
1) If the vend drop position is below the normal
position,
change the Y Motor on the rail.
2) Ensure the link connecting the flap to the motor
is not broken.
Call Tech Service: 1-800-344-7216
The clamp closes
but does not open
fully. While attempting to
operate, the clamp
fingers close but
cannot open to their
original position. Test clamp motor in Test Motors Mode. Perform Clamp Open test. If it does not open all the
way, check whether the compression spring is seated
correctly.
Perform Clamp Close test. In the clamp closed
position, check to see if the fingers are stuck.The
fingers should move easily when pushed out.
If the Clamp is working properly in 'Test Mode', change
the clamp sensor board.
In the problem persists, change the clamp motor.