Vendo VARI-PAK 450, Manual

Page: 54 / 113

PG-22
07/2003
PG-23
07/2003
Error Codes
(sub-codes indented)
Description
Error codes are cleared by pressing
selection button # 4 for 2 sec. when displayed,
or automatically by the following activities:
No error exist
Vend mechanism summary error
Control system summary error
Door switch open for more than 1 hour
RAM check sum of service mode settings
A/C supply low
Scale factor incompatibility
Vendor inlet coin chute sensor is blocked
Vendor inlet coin chute is blocked
Selection switch summary error
Selection switch error in switch XX
Space to sales summary error
Unassigned column
Changer summary error
No changer communication
Tube sense error
Changer inlet chute blocked
Tube payout jam in coin type XX
Changer ROM check sum error
Excessive escrow attempts
Coin jam
Acceptance rate below 80%
Disconnected acceptor
Coin routing error
Bill validator summary error
No bill validator communication
Bill validator stacker full
Defective bill validator motor
Bill validator jammed
Bill validator ROM check sum error
Bill validator stacker is open or out of position
Bill validator sensor error
Card reader summary error
No card reader communication
Card reader non-transient error; code X, subcode Y
Refrigeration summary error
Temperature sensor defective or unplugged
Cabinet temperature 3°F below low limit
Cabinet temperature 3°F above high limit
Cooling system not cooling
Heating system not heating
Vend Sensor Error
Door Switch
RAM
A/C Low
Scaling Factor
Inlet Sensor
Inlet Blocked
Select Switch Error
Selection XX
Space to Sales Column Error
Unassigned Column XX
Changer Error
No Communication
Tube Sensor
Coin Inlet
Tube XX Jammed
Checksum
Excessive Escrows
Coin Jam
Low Acceptance
Disconnected
Coin Routing
System Error
Bill Validator Error
No Communication
Stacker Full
Motor Error
Jammed
Checksum
Stacker Open
Sensor
Card Reader Error
No Communication
Code XY
Refrigeration Error
Sensor
Too Cold
Too Hot
Not Cooling
Not Heating
None
Door switch closure detected
Change any service mode setting
Scale factor corrected
Blockage removed
Coin detected by changer
Selection switch opens
Column is assigned
Proper communication received
Changer corrected
A coin is sensed
Changer corrected
Changer corrected
A valid coin is sensed
A coin is sensed
Acceptance rate above 80%
Acceptor properly connected
Coin is routed properly
Proper communication received
Receive stacker command
Validator becomes enabled
Validator becomes enabled
Validator becomes enabled
Validator becomes enabled
Validator becomes enabled
Error stops being reported
Proper communication received
Sensor detected
Temperature rises above low limit
Temperature falls below high limit
System cools 1°F per hour
System heats 1°F per hour
VEC 14.1 Diagnostics Error Codes
Vend Sensor Error Vend Sensor 1 Check or replace vend sensor assembly
Vend Sensor Error Vend Sensor 2 Check or replace vend sensor assembly
Escrow return mech. error Escrow Return Mech. Check or replace escrow return mech assembly
Vend mechanism summary error
Column jam in column XX
Vend Mech Error
Column Jam XX Complete a test vend cycle for column XX
Space to sales summary error
Unassigned selection
Space to Sales Selection Error
Unassigned Selection XX Selection is assigned
Cabinet switch open for more than 1 hour Cabinet Switch Cabinet switch closure detected