Vendo VARI-PAK 450, Manual

Page: 35 / 113

PG-2
07/2003
PG-3
07/2003
Diagnostics
See attached error code chart on page PG-22 for errors and how to clear them.
When you enter into the Diagnostics mode with selection button #4, the first one of the
summary error codes will be displayed. If no errors have occurred since the last error reset,
the display will show an Error None message. Pressing selection button #2 (up) or selection
button #3 (down) will cycle through all of the summary error codes. Pressing selection button
#4 will allow access into the detailed error code, while pressing selection button #1 returns to
the Diagnostics display.
Coin Payout
Allows you to payout coin tubes.
•
Press selection button #4 to enter into Coin Payout mode.
• Press selection button #2 (up) or selection button #3 (down) to choose denomination.
•
Press selection button #4 to dispense displayed denomination.
• Press selection button #1 to exit mode.
Tube Fill
Allows you to fill coin tubes via external coin insert. This is the recommended way to fill the
coin tubes because the control board is able to keep an accurate count of the coins.
•
Press selection button #4 to enter into Tube Fill mode.
• Insert coins into coin insert slot and the controller will “count” the number of coins going
into the coin mechanism.
• Press selection button #1 to exit mode.
Test Mode
Allows you to test vend a column, selection switches, display, refrigeration relay, light relay,
heater relay and evaporator fan relay.
Test Mode - Vending
•
At
Test
mode, press selection button #4.
• Display will read Test Mode – Vending .
• Press selection button #4.
•
Display will read Test Mode – Vending; Column A1.
• Press selection button #2 (up) or selection button #3 (down) to choose desired
column.
• Press selection button #4 to vend the displayed column.
§
If motor vends OK, display will read “ Motor OK ”
§
If motor does not test OK
§
Fail - Motor not Found will be displayed