Programming Manual
GLASSFRONT VENDING MACHINES
Rev. 1.12
MODELLS: G-DRINK SVE GF6 / GF9 – DR6 / DR9
Page 4 of 42
1.1 DESCRIPTION OF FUNCTIONS AND FEATURES
INITIALISATION
Each time the door is open and closed, the lift and catcher system will perform an
initialisation in order to detect the shelves position. In order to avoid not needed
initialisations, if the door is open for less than 60 secondes, the initialisation is not
performed assuming nothing has changed rearding the shelf configuration during this
short time. During initialisation the machine will automatically detect the position and the
number of shelves. Only setting the number of trays (2 or 3 trays) is required.
Selection counting starts at the left side of the upper shelf with number 11 to 16 (or 19),
next shelf starts with 21 to 26 (or 29) and then going to the bottom shelf.
Maximum number of shelves is 7.
2 Trays means 6 columns/selections per shelf
3 Trays means 9 columns/selections per shelf
From version software V1.29, at power ON the lift will proceed first to the delivery bucket
in order to download remaining product in the hand bucket.
LOADING FACILITY
In order to allow easier loading of the bottom shelf, pushing the delivery flap will move the
bucket to the right side, pushing the flap again will move the bucket to the left side.
DRUM FEATURE
When a product is detected inside the drum, the LED light is switched on in the drum, and
the drum is unlock and goes in position open. If the product is not removed after 2 minutes
the light is switched off, while the message
“REMOVE THE PRODUCT
“
alternatively with
arrows pointing in downwards is displayed. When the product is removed, the lights will
blink a short time before closing the drum
SOLD-OUT FEATURE
A magnetic sensor included in the delivery door flap allows the detection of the product
falling down the drum, if a selection is done with no product inside the columns, the
machine will put this selection in soldout until the door is open-close assuming the
selection has been reloaded.
GRAPHIC DISPLAY
During standby, in normal condition the machine will scroll a message in graphic 16x8 bits
higher character alternatively with correct change status message if any.
Also when the product have been detected the display will scroll the message
“REMOVE
THE PRODUCT
“ alternatively with arrows pointing in downwards.
