Velasa Sports Sparx ES100, Operating Manual

Page: 22 / 208

OPERATION
18
SHARPENING SKATES
To watch the How-To video, visit
sparxhockey.com/sharpening
Once you have loaded the skate, closed the
Protective Slot Covers , and adjusted the
height of the Grinding Ring , you are ready to
begin sharpening.
To cancel the cycles at any point during the
sharpening, press the
n Cancel Button once.
This will send the Carriage back to its home
position at the end of its current pass.
1 BEGIN SHARPENING
Press the p Play Button . Once the button
has been pressed, it will change from white
to blue and the sharpening process will
begin.
Upon pressing the p Play Button , the Air
Filter fan and grinding motor will turn on.
The Cycle Counter will flash with the current
cycle number until that cycle (out and in) is
completed. The sharpener will continue to run
until all cycles have been performed.
At the completion of the final cycle, the end
of sharpening is marked by a “cycle complete”
tone and the case LEDs will turn green. The
fan will continue to run for an additional
30 seconds after the final cycle completes.
ADDITIONAL CYCLES
If additional cycles are desired, you can reset
the cycle count and press the
p Play Button
again.
If the Grinding Ring skips when it first
makes contact with the blade, the Grinding
Ring’s height is too high. When properly set,
the Grinding Ring should make a smooth
transition onto the skate blade.
UNLOADING A SKATE
To watch the How-To video, visit
sparxhockey.com/unloadskate
1
DISENGAGE PROTECTIVE
SLOT COVERS
Move both Protective Slot Covers (A)
away from the skate.
On the ES100, the safety light on each
cover (B) will illuminate when moved away
from skate.
B B
A
2
REMOVE THE SKATE
Press and hold down the Clamp Lever to
open the Skate Clamp . Remove the skate
from the Skate Clamp and release the
Clamp Lever.