Velasa Sports Sparx ES100, Operating Manual

Page: 16 / 208

SETUP
12
5
PLUG IN THE POWER CORD
Plug the Power Cord into the Power Input
Port on the back of the sharpener. Plug
the other end into a wall outlet. Toggle the
switch on the
Power Input Port
to the on
position (I=on, 0=off).
A
Transporting or moving the Sharpener
without the Travel Guard & Travel Screw
installed voids your Warranty and/or
Extended Service Plan. Always remove
the Travel Guard & Travel Screw before
operating the Sparx Sharpener.
INSTALLING THE
PV100 VACUUM
PS100 Skate Sharpener Only
1
CONNECT THE SUCTION
HOSE
Install the Vacuum near the sharpener,
preferably at floor level, or under the table
that the sharpener is installed on. This
is recommended for noise suppression.
Connect the included Suction Hose
directly from the Exhaust Port to one of
the vacuum’s inlet ports.
2
CONNECT THE FOOTSWITCH
If using an accessory
Footswitch
, connect
the power cord for the Vacuum to the
Footswitch and connect the Footswitch
Power Cord to a wall outlet. Ensure that
the power switch for the Vacuum System
is turned on. The
Footswitch
can then
be used to turn the Vacuum on during
sharpening, and turn the Vacuum off when
sharpening is complete.
ALIGNMENT
To watch the How-To video, visit
sparxhockey.com/alignment
The Alignment process is required when
you first receive your Sparx™ Sharpener and
also after every time the sharpener is moved
and/or travels.
1
INSTALL THE ALIGNMENT
RING
Open the Glass Door . The Carriage
will automatically move into the install
position, and the sharpener will play a
“ready” tone. While holding the Grinding
Ring Shaft (C), unscrew the Thumb Nut
(A). Slide the Alignment Ring (B) onto
the Grinding Ring Shaft (C), with the label
facing out. Replace and tighten the Thumb
Nut until hand-tight. Close the Glass Door .
A
B
C
2
INSTALL THE OPTICAL
ALIGNMENT TOOL
Press down on the Clamp Lever to open
the Skate Clamp . Place the Optical
Alignment Tool (with Sparx™ logo facing
towards the user) into the Skate Clamp .
Place the Optical Alignment Tool into the
slot and let it fall into place. Release the
Clamp Lever .