9 / 43
through the plastic panel. Connec t cables to hole of pin. See Pi
Pic. 17
Pull cables into the back box
c. 18
Pic. 18
Insert the hole of pin inside the back box. When finished, close the door to the back box and turn on the power. The LED
will light up. See Pic. 19.
Pic. 19
If the LED does not light up, refer to Section 5: Trouble Shooting.
Step 3.
Install dome drive
Set the DIP switches for SW1 and SW2 at the bottom of the camera drive for the appropriate receiver address,
communication protocol, and baud rate. Refer to the labels on the camera drive or DIP SWITCH SET in this manual.
Remove cover of camera and sponge. See Pic. 20
Pic. 20
Line up link card and faucet of the back board of the dome. Push the dome drive in. See Pic. 21
