Run
9
________________________________________________________________________________________
_______________________________________
9
-
47
It is also possible to start and stop the feed rollers by pressing the start button (960) while
traversing the panel. Pressing the start button again will re-commence the feed.
NOTE: if this is done during a gluing cycle, the pause must be very short because the
heat from the glue nozzle will deform the band material depending on the characteristics
of the band.
It is now possible to check the results of the test trim to determine if any adjustment is
required for the trimmer. This will mean that only a small section of tape is trimmed and
can be checked. Further adjustment can then be made and the same panel can be used
to further check the setup.
This means in most cases the trimmer can be set using only a single panel. On
completion of this setup, retain this panel for testing the scraper setup (ref section 9.1.9)
NOTE
This process can be performed any time to trim panels without applying edge material.
For the purpose of the above test, a simple rectangular panel was used which meant that
the functions listed in 9.2.4 were all turned off. However, if it is desired to “trim only” a
more complex shape, then the above procedure should be repeated but with any
appropriate functions turned on. See section 9.3 for information on how these functions
can be used.
926
960
976
977
975
947
959
950
951
933
993
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...