Run
9
________________________________________________________________________________________
_______________________________________
9
-
31
This drawing is available in dxf format on request.
The reason that there are 3 holes (964) for fixing is that this plate is universal.
The left hand side of the plate above is straight and is used when needed as a start block.
Therefore only the two left hand 8mm holes (964) are required and in fact the entire right
hand side can be cut off if unnecessary or obstructing in some way.
Similarly when making a finish block, the right hand side is used and the two right hand 8
dia holes (964) are used.
The radius on the end of this surface allows the head to travel around the end when
completing the trimming and scraping function.
These vacuum pods have two hoses for the vacuum. One is connected to the permanent
vacuum rail (lower) of the vacuum manifold and serves to hold the vacuum pod to the bed
of the machine even when the control vacuum is switched. The second hose is
connected to the control vacuum (upper) rail of the vacuum manifold and is turned on and
off with the vacuum control switch (945) on the front panel.
Control
Vacuum
Fixed
Vacuum
Fixed
Vacuum
Control
Vacuum
Hose
holder
945
946
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
