Run
9
________________________________________________________________________________________
_______________________________________
9
-
54
9.2.8.1
Setting the Glue Joint (surface) Scraper
The glue joint surface scraper (901) is a unit suspended from the trimming unit with a
pneumatic cartridge cylinder (902) pressing the scraper knife arm down onto the panel.
(900)
The knife has adjustments which allow it’spressure, flatness to the panel and angle of
attack to be adjusted.
This is achieved by commencing a cycle on a panel which has had banding applied
already without trimming. This enables the head to be stopped and started as it travels
around the panel using the start button.
The cycle is started with the trimmer and scraper on. Allow the head to travel around the
panel until it is in a position giving good access to the scraper system. At this point, stop
the cycle using the START/HOLD button (960).
DANGER!
Opening the front hood will now disable the trimmer. The trimmer is electronicall braked
and will slow quickly but it is good practice to make sure the trimmer is fully stopped
before approaching.
If the scraping is not performing as desired it is possible to make adjustments.
It is recommended to do these in the following step order.
902
901
900
901
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
