GC
™
12 MARINE CAMERA
INSTALLATION
INSTRUCTIONS
Mounting Considerations
You can mount the camera upside-down or sideways. You can
reverse the camera image to use in rearview mode. See your
chartplotter owner's manual for instructions.
You should mount the camera in a location where it is
• not an obstacle in doorways or walkways.
• not exposed to extreme temperatures.
• not exposed to gas or oil.
• not exposed to radioactivity.
• not facing into direct sunlight or a direct reflection of sunlight.
Tools Needed
• 1 A fuse or circuit breaker
• Drill and 2 mm (
1
/
16
in.) drill bit
Mounting the Camera
1
Secure the template
À
to the mounting location.
2
Using a 2 mm (
1
/
16
in.) drill bit, drill the pilot holes.
3
Adjust the dome base
Á
to the correct orientation for your
desired camera tilt.
4
Secure the dome base to the mounting location using the
included tapping screws
Â
.
5
Insert the camera
Ã
into the dome base.
6
Secure the set screws
Ä
into the dome front
Å
using the
included wrench.
Installation Considerations
You must connect the camera power wire to the battery through
a 1 A fuse or circuit breaker. If you do not use a fuse or circuit
breaker, the camera can malfunction.
Some Garmin
®
GPSMAP
®
chartplotters have a built-in CVBS
video encoder. Video from the camera or cameras appears on
all chartplotters on the network when plugged into a single
CVBS IN port. Go to
compatible GPSMAP chartplotters.
If you want to use more than one camera or the chartplotter
does not have a CVBS IN port, you must use an encoder.
You can add up to four cameras to one encoder and up to two
encoders to the Garmin Marine Network.
Installation Diagram
À
GC 12 Marine Camera
Á
1 A fuse or circuit breaker (not included)*
Â
12 Vdc Power source
Ã
BNC to BNC Coax Video Cable (not included)
Ä
Compatible Garmin chartplotter
*You must connect the camera power wire to the battery through
a 1 A fuse or circuit breaker. If you omit a fuse or circuit breaker,
the camera can malfunction.
Installation With Encoder Diagram
You can add more than one camera to your network when you
use an encoder.
À
GC 12 Marine Camera
Á
1 A fuse or circuit breaker (required, not included)*
Â
12 Vdc Power source
Ã
BNC to BNC Coax Video Cable (not included)
Ä
Network cable
Å
Power-over-Ethernet isolation coupler (GPN 010-10580-10)
Æ
Garmin Marine Network cable
Ç
Axis
®
Q7424 Encoder (optional/not included)
È
Compatible Garmin chartplotter
*You must connect the camera power wire to the battery through
a 1 A fuse or circuit breaker. If you omit a fuse or circuit breaker,
the camera can malfunction.
Troubleshooting
Video Does Not Appear on the Chartplotter Screen
• Verify all cables are firmly connected.
• Verify the video cable is connected to the camera video
output port.
Image on the Chartplotter Screen is Dim or Dark
• Verify the lens is clean. If necessary, wipe the lens with a
soft, clean cloth.
• If the camera is exposed to too much direct light, change the
camera position or location.
August 2018
190-01087-01_0A
