VDH Products BV
Document 063319 - version 3.12
Page:
29 of 78
4.1.1.3 Network
If the
PROBA110
is connected to a network, a small printed circuit board (the network interface) has to
be present. This printed circuit board is standard mounted by VDH, so that the
PROBA110
is always
prepared for a network connection.
4.2
Settings of the PROBA110
How the
PROBA110
responds to control and signals failures, depends on a number of parameters which can be set by the
user or installer:
*
general settings
*
program settings
*
control settings
*
alarms/warnings
*
hardware settings
Normally these settings do not have to be changed daily. This is why they are more difficult to access than e.g. the starting or
stopping of a ripening program or the changing of a setpoint.
Adjustment of these settings is referred to as 'Internal Programring'.
Make sure that the key is in the
PE
position.
The
PROBA110
can be brought into the Internal Programming mode by
simultaneously pressing the
RESET-ALARM
and
SET
key. Start by pressing the
RESET-ALARM
key; then the
SET
key.
After five beeps the first Internal Parameter appears in the lower display. The
RESET-
ALARM
and
SET
key can now be released now.
The upper display shows the value of the first parameter.
In Appendix E (Internal Parameters; page 48) all Internal Parameters are stated. The
table gives a description of the parameter, the range and the default value.
The parameters are split into main groups. By pressing the
ZONE/HEAT
key together
with the
UP
or
DOWN
key one can go through the main groups.
With the
UP
and
DOWN
keys the separate parameters can be viewed.
By pressing the
SET
together with the
UP
or
DOWN
key, the value of the selected
parameter can be changed.
Stop the Internal Programring by pressing a little longer than normal the
RESET-
ALARM
key. The
PROBA110
will give a beep. This indicates that the new settings are
stored.
If during Internal Programring no key is touched for 60 seconds, the
PROBA110
automatically switches back to the normal operation mode. All settings that are
entered so far are stored.
Summary of Contents for PROBA
Page 73: ...VDH Products BV Document 063319 version 3 12 Page 73 of 78...
Page 75: ...VDH Products BV Document 063319 version 3 12 Page 75 of 78...
Page 76: ...VDH Products BV Document 063319 version 3 12 Page 76 of 78...
Page 77: ...VDH Products BV Document 063319 version 3 12 Page 77 of 78 Jumper settings...