VBrick dme, Admin Manual

Page: 89 / 219

System Configuration
DME Admin Guide 77

To access the SNMP fields:
1. Navigate to
System Configuration
>
SNMP
.
Field Description
SNMP Server Running Default = False. Enabled on the Security page. Must be
enabled to allow SNMP reads and traps.
Read Community The community string used for SNMP v2 and v1 read access.
May include any combination of alphanumeric characters and
only the underscore special character.
SNMPv3 Username Default = "SNMPadmin". May include any combination of
alphanumeric characters and only the underscore special
character.
SNMPv3 Authentication
Password Enter password. Must be at least 8 characters. May include
any combination of alphanumeric characters but only the
following special characters: ~ ! # $ ^ * + & [ ] { } | < > _
SNMPv3 Authentication
Protocol Select protocol: MD5 or SHA. Select the authentication
protocol that matches the set up in the SNMP management
tool you are using. If both are present in the management
tool, SHA is regarded as the more secure choice.
SNMPv3 Privacy Password Required. Must be at least 8 characters. May include any
combination of alphanumeric characters but only the
following special characters: ~ ! # $ ^ * + & [ ] { } | < > _
SNMPv3 Privacy Protocol Select protocol: DES or AES. AES is more secure and should
be selected here unless your management tool does not
support this protocol.
SNMPv3 Security Level • Authentication Only (Default)
• None (No Authentication or Privacy)
• Authentication and Privacy
Trap Mode Default = Traps Disabled. Used to enable v2 or v3 SNMP
Traps.