M
ENU
S
YSTEM
: C
UES
AND
S
EQUENCES
4
02.9661.0001 K
09-Apr-03
57
Cue Operations
The following section provides instructions for performing cue, sequence, and playback operations.
Note:
The
Mod
,
Del
,
PCue
,
PSEQ
commands will all display "
---
" if no cues have been stored.
Note:
After 10 seconds of inactivity at the display, it will change to the default state showing the
address.
To use the menus:
The data stored by the luminaire is “last takes precedence.” This means the last command received by
the luminaire will be the basis of the cue to be stored.
To clear all input data and timing values from previous tests or cues, cycle power to the luminaire with
DMX data cables disconnected. This will reset parameter’s data and timing values to defaults.
Set position:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Man
appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows until desired parameter appears. Press [Enter].
Step 4. Press [Up] / [Down] arrows to adjust value. (The values wrap from 0 to 255 in either
direction. Pan and Tilt values operate in a range of 0-4095, and wrap also.) Press [Enter] to
set value.
Step 5. Parameter timing can be set using the
Time
sub-functions. This allows timing to be added
to Intensity, Pan & Tilt, Color, and Beam parameters.
Set follow time between cues:
The following procedure is used to set the follow time between each cue. The value can be different for
each cue. The range is 0.0 to 365.9 seconds.
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Cue
appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows until
FLTM
appears. Press [Enter].
Step 4. Press [Up] / [Down] arrows to set value. Once the value is set press [Enter] button. The
display will return to
FLTM
.
