www.vareximaging.com
23
4343W/4336W-G5/2530W-G5 X-ray Detectors
11.4
X-ray Detector Battery
This section describes installing and removing the battery, battery charge status, and battery
hot-swap.
Note
New batteries are shipped from Varex in shut-down mode. Before installing
into the X-ray detector, the battery must be inserted into the 1 or 3-bay
charger to remove it from shut-down mode.
Note
For additional PDF information about the Varex Imaging Wireless Battery
and Chargers, visit
www.vareximaging.com
.
11.4.1
Battery Installation
1
Insert Battery at a slight angle so that the side with contacts sits over the adjoining contacts in
the battery compartment.
Note
When inserting the battery the angle of the battery should not be more than
20 degrees, inserting a battery at a larger angle could cause damage to the
battery contact pins.
2
Lay the battery down, with the side opposite of the battery contacts slightly lifted.
3
Press down on the lifted side of battery, the battery will snap into place in the battery
compartment.
4
The X-ray detector is now ready for use.
Figure 12 Representation of Battery Installation
R
E
FE
RE
NCE
M
ANUAL
