E5
−
H High Performance Universal Inverter User Manual
106 Chapter
6
Parameter
Description
If the input terminal function is set to 32 (forced wake up input function). When the inverter is in sleeping
status, if close the terminal (terminal function be set to 32), the inverter will out of sleeping and enter PID
regulation process.
If the output terminal function is set to 32 (sleeping instruction). When the inverter is in sleeping status, the
terminal which function number be set to 32 is enabled.
If need to use terminal to switch close loop control and open loop control, the input terminal function
number should be set to 51.
Setting other PID parameters in P8 group, for details, refer to group P8 parameters discription.
6.19 User
−
defined Function Code Displayed/hidden Zone Parameters
(Group A0)
Customize function code menu by function code of group A0. Protect the customized menu with
password A0.00.Only function code groups with corresponding Bit set to 1 by A0.01 or A0.02 can be
shown.
Note:
Factory default for password of displayed/hidden zone of user
−
defined function code is 1.
LSB (the least significant bit) to MSB (the most significant bit) of A0.01 correspond to P0, P1, P2,
P3, P4, P5, P6, P7, P8, P9, PA, Pb, PC, Pd, PE and d0 in turn.
LSB to MSB of A0.02 correspond to d1, d2 and reserved 14 bits in total.
Zones of PE, C, U0 and U1 are reserved for parameters by manufacturer.
When recovery practices of function code P0.01=4 or 5, the displayed/hidden function will be
reset back to factory default.
A0.00
Password of displayed/hidden zone of user-defined function code
0~FFFF(1)
A0.01
Displayed/hidden function 1 of user-defined function code
0~FFFF(FFFF)
A0.02
Displayed/hidden function 2 of user-defined function code
0~FFFF(FFFF)
P5.00
～
P5.04
X1
to
X4 terminal input function selection
0
～
99
（
99
）
P7.00
Y1 terminal output function selection
0
～
47
（
0
）
P7.02
Relay terminal output function selection
0
～
47
（
14
）
