Vacon NX OPTC7, User Manual

Page: 27 / 52

FAULT TRACKING vacon • 27
24-hour s358 (0)40 837 1150 • Email: vacon@vacon.com
APPENDIX 1
Vacon DeviceNet Interface Errors
The OPTC7 DeviceNet interface records the following events in the Event List FIFO:
VACON Event Name Event Code Event Description
No event 0x00 Default value in EventList
entries.
Drive Communication Error 0x01 Inverter interface communication
error with the drive.
I/O Connection Timeout – Fault_Stop 0x02 Control Supervisor transitions to Fault_Stop.
I/O Connection Timeout – No Action 0x03 Control Supervisor remains in Enabled State.
Hold last speed
I/O Connection Timeout – Preset
Direction and Speed
0x04 Control Supervisor remains in Enabled State.
Run at preset direction and speed.
Explicit Connection Timeout – Fault_Stop 0x05 Control Supervisor transitions to Fault_Stop.
Explicit Connection Timeout – No Action 0x06 Control Supervisor remains in Enabled State.
Hold last speed
Explicit Connection Timeout – Preset
Direction and Speed 0x07 Control Supervisor remains in Enabled State.
Run at preset direction and speed.
Low DeviceNet Voltage 0x08 Connection timeout may occur next.
Bus Off 0x09 Connection timeout may occur next.
CAN Overrun 0x0C Connection timeout may occur next.
Configuration Consistency Value (CRC)
mismatch 0x0E The device’s configuration is incorrect or
incomplete. Major Recoverable Fault. An
Identity Reset type 1 is needed for recovery.
Microprocessor watchdog timeout 0x0F The device detected a serious problem with
itself. Major Unrecoverable Fault.
Received explicit message is too big 0x10 Message is ignored.
Received IO message is too big 0x11 Message is ignored.
Parameter Range Error 0x12 An out-of-range parameter value exists in
the drive.
I/O Connection Released – Fault_Stop 0x14 Control Supervisor transitions to Fault_Stop.
I/O Connection Released – No Action 0x15 Control Supervisor remains in Enabled State.
Hold last speed
I/O Connection Released – Preset Direction
and Speed 0x16 Control Supervisor remains in Enabled State.
Run at preset direction and speed.
Receive_Idle – Fault_Stop 0x17 Control Supervisor transitions to Fault_Stop.
Receive_Idle – No Action 0x18 Control Supervisor remains in Enabled State.
Hold last speed
Receive_Idle – Preset Direction and Speed 0x19 Control Supervisor remains in Enabled State.
Run at preset direction and speed.
Explicit Connection Released – Fault_Stop 0x1A Control Supervisor transitions to Fault_Stop.
Explicit Connection Released – No Action 0x1B Control Supervisor remains in Enabled State.
Hold last speed
Explicit Connection Released – Preset
Direction and Speed
0x1C Control Supervisor remains in Enabled State.
Run at preset direction and speed.