8
vacon • 80
Options
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
8.4.6
Parameter menu
In Parameter menu only the Quick setup parameter list is shown as default. To view the other ad-
vanced parameter groups, see the Application Manual. The following figure shows the parameter
menu view:
Figure 56.Parameter menu
Change the value of a parameter following the procedure below:
1.
Locate the parameter.
2.
Enter the Edit mode by pressing OK.
3.
Set new value with the arrow buttons up/down. You can also move from digit to digit with the
arrow buttons left/right if the value is numerical and change then the value with the arrow but-
tons up/down.
4.
Confirm change with OK button or ignore change by returning to previous level with Back/
Reset button.
OK
OK
2
Press Right to browse
otherPar. group
4
Press OK button to enter
edit mode
3
Press down button to
browse P3.4
5
Press Up / Down to change value
OK
6
Press OK to confirm
FA U LT
A L A R M
S TO P
R E A D Y
R U N
FA U LT
A L A R M
S TO P
R E A D Y
R U N
FA U LT
A L A R M
S TO P
R E A D Y
R U N
F W D
R EV
I/O
K E Y PA D
B U S
F W D
R E V
I/O
K E Y PA D
B U S
F W D
R E V
I/O
K E Y PA D
B U S
1
Press OK to enter Pa r. menu
FA U LT
A L A R M
S TO P
R E A D Y
R U N
F W D
R E V
I/O
K E Y PA D
B U S
FA U LT
A L A R M
S TO P
R E A D Y
R U N
F W D
R EV
I/O
K E Y PA D
B U S
Hz
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
