DS1061-015B
33
5.5.3 TELEPHONE COMMUNICATORS CONFIGURATION
To.locally.program.basic.parameters.of.he.system,.follow.the.instructions.below:.
1.. Select.the.desired.system.from.
Plants list
and.press.the.button.
Communicators
..
.. On.the.display.appears.
Communicators
, that allows to configure the PSTN telephone communicator and the GSM module.
The following parameters are configurable:
Phone options:
Communicators
,. where. it. is. possible. to. indicate. if. in. the. control. panel. are. installed. the. PSTn. telephone. communicator,. the. GSM.
module or both of them. If both of them are installed, it is also possible to select, with priority, which one must be used first.
Phone call check
,.that.allows.to.set.the.following.parameters:
Answer control
,.that.recognizes.the.call.signal,.after.the.number.has.been.dialled..If.the.answer.check.is.enabled,.the.communicator.
waits.until.the.called.number.answers,.before.playing.the.alarm.vocal.message.(if.the.call.signal.is.not.recognized,.the.alarm.vocal.
message is played anyway, after some seconds from the end of the dialled telephone number). If disabled, the vocal message is
played..seconds.after.the.the.telephone.number.has.been.dialled..
Tones control
, if enabled, it dials the number only after the dial tone has been detected; if disabled, it enters the number 3 seconds
after the line has been seized. If the GSM communicator is installed, it enables the field test before the calls cycle.
Incoming call rings
,.that.allows.to.set.the.rings.number.before.the.control.panel.answers.an.incoming.call..If.the.rings.number.is.set.
to.“0”,.incoming.calls.are.ignored..
Phone line test
.tests,.allows.to.select.one.of.the.following.options:.
Disabled
,.disables.the.test.used.to.check.the.telephone.line.correct.operation..
Enabled without SAG alarm
, enables the automatic test for telephone line check (failure or no line). The test is performed each time
•
•
•
•
•
•
•
•
•
