17
Maintenance And Service
b
uRneR
c
onveRsion
5”
x
8” v
enting
:
By default, the burner comes set for use with 8” x 11” venting. If planning to use 5” x 8” venting, a small
conversion to the burner is needed:
1. Remove the safety screen (see
M
aIntenance
a
nD
s
erVIce
- r
eMoVe
s
afety
s
creen
on page 10).
2. Remove the door trim (see
M
aIntenance
a
nD
s
erVIce
- r
eMoVe
D
oor
t
rIM
on page 11).
3. Remove the glass door (see
M
aIntenance
anD
s
erVIce
- G
lass
D
oor
r
eMoVal
on page 11).
4. Near the rear of the burner box, there are
two small cover plates (one on each side).
Remove the two (2) T-20 screws securing
each of the cover plates onto the burner
box (see Figure 21). This provides more air
to the burner and makes a difference when
using 5” x 8” venting.
Note - Depending on vent setup, it may be
required to leave the right side cover plate
installed to prevent undesired pilot behaviour.
Figure 21: Burner Conversion 5” x 8” Venting
F
ueL
c
onveRsion
:
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
Please read and understand these instructions before installing.
Warning: This conversion kit shall be installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not proper or complete until the
operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
Kit Parts List for all U44 Models:
1 - LP Stepper Motor w/ Hardware
1 -
Burner Orifices (
LP: #40)
1 - Pilot Orifice (NG: 0.2) or (LP: 0.14)
c
onveRsion
k
it
i
nstaLLation
:
1. Disconnect the gas supply completely as well as any electrical power source before proceeding.
2. Remove safety screen, door trim, glass door, log grate, and burner (see
M
aIntenance
anD
s
erVIce
section of
Owner’s Manual
).
3.
Convert the existing burner orifice with the ones provided in this kit using a 1/2 inch socket.
2 - Conversion Labels [included with unit]
Carefully inspect all parts supplied with this conversion kit. If any parts have been damaged or are missing,
contact your dealer, distributor or courier company to have them replaced before starting this installation.
