VersaPro Temperature Controller
Page 12
Copyright © 2013, United Process Controls Inc.
All rights to copy, reproduce and transmit are reserved
Figure 2 Wiring Schematic
4.1 Mounting
To mount the instrument in a control panel, a hole must be cut 3.62" square in the necessary location on the
panel. The following procedure should be followed to mount the VersaPro in the panel.
1)
Insert the unit into previously cut out 3.62" square hole in panel.
2)
While supporting unit, insert one clamping bracket into the groove on the bottom of unit, and then install
the 6-32 set screw.
3)
Repeat step 2 for the top of the unit.
4)
With a HEX KEY wrench, alternately tighten the screw on either side of instrument to a torque of six in.-
lbs. Insure rigidity of mounting. DO NOT OVER TIGHTEN. This can wrap the instrument enclosure
and make removal difficult.
To remove the instrument from the panel, reverse the above procedures.
