![background image](http://html1.mh-extra.com/html/unitec/5-1026/5-1026_operation-and-maintenance-manual_3978697009.webp)
P n e u m a t i c
C h a i n S a w
5 1 0 2 6 – 5 1 0 2 9
51026_51029_BA_en_Version_05
Page
8
of
34
Who is working with a motor saw has to be fit
-
awake, healthy and in good shape
-
has to lodge working breaks in good time
-
is not allowed to work with such a saw while you are under the influence of
-
medication, alcohol, or other drugs, because that can affect the reaction.
With hear protecting that has been put on, you have to be attentive and careful, because the
recognizing of dangerous sounds (screaming, signal sounds, etc.) is disturbed.
Do not work alone!
You have to keep a position where other people can hear you, if an accident happens and you
start screaming.
Do only use attachments, which have been delivered by SPITZNAS or have been explicitly
released for the attaching!
Other attachments are not allowed to be used, because they could lead to bigger dangers.
SPITZNAS takes out any liability for person- and property damage, in which use of not
approved attachments has occurred.
Before starting the saw
Check if the saw is in safe condition.
Observe the corresponding chapter in the operating manual:
The guide (bar) has to be fixed properly
Chain has to be tensioned properly
Valve lever and valve lever latch have to be fingertip easy.
Valve lever has to rebound into the neutral position by itself.
Do not make changes concerning the operating and safety equipment!
Keep the handles clean and dry from resin – for the safe guiding of the motor saw!
Correct operation pressure (see technical specifications)
Chain-break must be in proper condition
When working in explosive areas, pay attention to proper lubricating and cooling of the
chain and the bar.
The chain saw should only be used in totally safe condition (Danger of accident).
Starting the chain saw
The chain saw is only used by one person. Do not tolerate other people in the working area!
Do always hold the saw tight in both of your hands for the proper guiding.
The right hand is holding the rear handle (even left-hander) - pipe handle and handle should be hold
tight with the thumb.
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
Translation of the original manual
compiled: 20.04.16