![background image](http://html1.mh-extra.com/html/unitec/5-1026/5-1026_operation-and-maintenance-manual_3978697017.webp)
P n e u m a t i c
C h a i n S a w
5 1 0 2 6 – 5 1 0 2 9
51026_51029_BA_en_Version_05
Page
16
of
34
Put the guide bar over the screws (4). (The cutting edges have to face to the right) and put the fixing
bore (5) over the pin of the clamp nut. At the same time put the chain over the sprocket (6). Turn
adjusting screw (7) to the right, until the chain still hangs out a little bit and the noses of drive links are
put into bar groove.
Attach the cover back and tighten the nuts lightly by hand.
After this, adjust tension of chain. (Paragraph „Adjust tension of chain“)
Assembly of spiked strip
2 x screw M 6
at motor housing
Tensioning the saw chain
Adjust tension during operation:
Stop motor and disconnect it from air supply. Only then loosen the nuts (1)!
Lift bar nose and screw clamp nut (1) with a screwdriver to the right until the chain lies at
the underside of the bar. Go on lifting up the bar and tighten the nuts (1) very strongly.
Check chain tension
Stop the motor.
Put on protecting gloves!
The chain has to lie at the underside of the bar and it has to be pulled over the guide bar by hand
when the chain brake is released.
If necessary, adjust tension.
A new chain has to be adjusted more often than a chain which is already used for a longer period.
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
Translation of the original manual
compiled: 20.04.16