Unipulse TM500, Operation Manual

Page: 75 / 165

4 SETTINGS AND CALIBRATIONS
66
Chapter
4
SETTINGS
AND CALIBRATIONS
3.
Shift
This is one of the waveform processing methods.
A part of waveform can be shifted up/down.
Operation
Setting range (range set under “Compare Area”)
Main screen
→
Setting
→
Work Setting
→
Wave Setting
→
Shift
①
To shift the HI limit waveform, press , and to shift the LO limit waveform, press
to select each waveform, and then press .
②
Determine the range you want to shift. To specify the left of the
range, press
, and then move the cursor.
To specify the right of the range, press , and then move
the cursor.
After specifying the range, press
.
③ Determine the amount of shift.
Touch the desired position, or specify the amount of shift
with , and then press .
4.
Tie Drawing
A waveform can be created or processed as desired by preparing
one or more points and tying the point(s) by straight lines. If
there is only one point, a spine-like waveform will result as
passing that point.
Operation
Setting range (1 to 10 points)
Main screen → Setting → Work Setting → Wave Setting → Tie Drawing
① To create/process the HI limit waveform, press , and to create/process the LO
limit waveform, press to select each waveform, and then press .
② Touching a desired position creates a point. To finely adjust the
point position, press the arrow key to move the point to the target
position.