UniPOS
Fire Control Panel FS5200
Instruction manual
Page 46
Revision 8/07.17
of 69
While selecting the function a screen for confirmation will
appear:
When you press button
the function is activated and the archive (information on events
saved in the energy-independent memory of the control panel) will be cleared.
The fire counter is not cleared here. Reset of the fire counter is possible in a special mode only,
Access level 4.
14.3.7. Function
Enter new password
Select the function from the screen:
When the function is activated appears the following screen
and the cursor is positioned over the first digit of 0000 (password):
The function allows the user to enter a new password for access to SetUp Mode.
15. Remote Control Mode
15.1. Description
The fire control panel enters Remote Control Mode when an external control unit of higher level
(
computer from a centralized dispatcher control point or other) sets the panel’s configuration
parameters via serial interface. In this case the fire control panel exits all other modes/conditions.
When the fire control panel operates in Remote Control Mode, it does not serve fire alarm lines,
controllable outputs either other periphery devices (all lines and outputs are switched off); it is under
the control of the external unit. When the fire control panel exits the mode, initial reset is being done
15.2. Indication
15.2.1. LED and sound indication
In this mode indicator
(Fault condition) illuminates in continuous yellow light, the local
sounder is switched off.
15.2.2. Text message
The following screen is displayed:
15.3. Using the keypad
No buttons are active in this mode.
16. Saving the parameters
All set parameters or modes of operation are being saved in the energy independent memory and
upon interruption of mains or backup battery supply they remain unchanged. When the fire control
panel is powered again, it operates according the preset parameters and modes. The default
parameters and modes are factory set (see section 14.3.5). The user password is set to 0000
Remote control
> Set Parameters <
New password 0000
> Set Parameters <
06 Clear archive
07 New password
> Set Parameters <
> Clear archive <
≡ - Confirm
х - Cancel
