UniPOS
Fire Control Panel FS5100
Instruction Manual
Page 27
Revision 7/06.12
Of 47
Press the
button to display the information screen
for a particular telephone number:
♦
n is the consecutive number of the telephone number;
♦
t is the type of dialing – P (pulse dial) or T (tone dial);
♦
XXXXXX is the telephone number and you may use symbols like #, *, comma and digits
from 0 to 9.
The maximum length of each telephone number is up to 20 characters, including the dial type.
If the total length of the telephone number is up to 12 characters it will be displayed in full. If
the total length is more than 12 characters the telephone number will be displayed on two
screens, the first one containing characters from 1 to 12, the second one containing the
characters from 9 to the last one. To switch from screen one to screen two and back, press
button
.
13.2.8. Menu
Adjustment
Select the menu from the screen:
This is the menu for adjustment (see section 14).
13.2.9. Menu
Archive review
Select the menu from the screen:
The menu displays information on the events saved in the energy independent memory.
First, an information screen for the total number of Fire
conditions stage II, registered after the initial start up of the fire
control panel is displayed; NNNN is the total number of Fire
conditions stage II.
The following information screens visualize specific information relevant to each event that has
been registered by the fire control panel:
−
Line N Normal – line number N has restored from Fire condition, Fault condition or Disable
mode;
−
Line N Fire 1 – line number N has entered Fire condition stage I;
−
Line N Fire 2 - line number N has entered Fire condition stage II;
−
Line N Disabled – line number N has been disabled;
−
Line N Rmvd FD – line number N has entered Fault condition: removed fire detector;
−
Line N Interr. – line number N has entered Fault condition: break in a line;
−
Line N Short – line number N has entered Fault condition: short circuit in a line;
−
Line N Rst test – line number N has entered Test mode;
−
Line N Rst test – line number N has exited Test mode;
−
Output N Normal – controllable output number N has restored from Fault condition or
disabling;
−
Output N Disabled – controllable output number N has been disabled;
−
Output N Interr – controllable output number N has entered Fault condition:Interrupted
controllable output;
−
Output N Short – controllable output number N has entered Fault condition: short circuit in
controllable output;
−
No 220V – the fire control panel has entered Fault condition: interruption in mains supply;
−
No 220V Rst – the fire control panel has exited Fault condition: interruption in mains supply;
−
Flt: Battery – the fire control panel has entered Fault condition: fault in backup battery supply;
−
Flt: Rst Battery – the fire control panel has exited Fault condition: fault in backup battery
supply;
−
Flt: Uuser –the fire control panel has entered Fault condition: fault in external devices supply;
−
Flt: Rst Uuser – the fire control panel has exited Fault condition: fault in external devices
supply;
FireNumbers
NNNN
Archive Review
Adjustment
Nn tXXXXXX
