unipo UFP 6", Operating Manual

Page: 34 / 96

Universal unipo® Flat Panel UFP
Installation and start-up
32
Revision status 19.01.2010
5.2 Installation
The installation of the UFP depends on the following factors:
• chosen optional accessories
Optional accessories are delivered with detailed installation instructions.
These operating instructions describe the installation of the UFP by means of front
plate and clamping claws.
• chosen input module
These operating instructions contain detailed installation instructions.
5.2.1 General installation procedure
• Install optional accessories.
• Plug the input module into the socket on the back of the UFP provided for this purpose
and fasten it with the supplied assembly material and the covering hood
(if not delivered in assembled state).
• Connect the protective earthing acc. to VDE.
• Connect the signal connection.
• If necessary connect the control unit.
• Connect the mains cable (depending on power supply module used).
The UFP-Chassis is provided with ventilation openings, which must never be blocked during
operation. Ensure sufficient air ventilation.
WARNING! Danger of overheating!
During operation of the unit an insufficient air circulation can lead to overheating
and therefore failure of the device! The ventilation openings must always be kept
clear.