Unical NUA, Installation And Maintenance Instructions Manual

Page: 72 / 112

18
J
Note:
To remove the stove from the pallet, the two 'U'
screws must be removed and the
'S'
plate removed
from the stove foot. There are four brackets.
3.3 - POSITIONING
The support surfaces and/or points must have a
load-bearing capacity to support the total weight
of the appliance, its accessories and coverings.
It is suggested that the side and rear walls and the
floor support surface be made of non-combustible
material.
We recommend placing a floor protector plate
near a chimney or flammable material (e.g.
parquet or carpet).
Position the stove and proceed with the connection
to the chimney. Find, by adjusting the 4 feet, the
right level so that the smoke outlet and pipe are
tight and free of smoke leaks.
If the stove is to be connected to an exhaust pipe
running through the rear wall (to feed into the
chimney), take great care not to force it in.
If the smoke outlet '' 9 '' of the stove is forced
or improperly used to lift or position it, the
operation of the stove is irreparably impaired.