Sowing Machine AMBER 900/3
20
10.1.2. THE FOLLOWING PROCEDURES MUST BE PERFORMED IN ORDER TO
PUT THE SOWING MACHINE INTO OPERATION:
•
make sure that the sowing machine is complete, and parts which are added
separately are placed in a packaging together with the machine – otherwise
contact the seller;
•
connect the sowing machine to a tractor according to instructions given in
section 10.1.2.1;
•
make sure that the particular mechanisms of the machine work correctly;
•
tighten all the nuts and screws;
•
fill all the greasing points with grease according to instructions included in the
section 10.1.2.3;
•
make sure that the oil level in the gear box is correct. Perform the procedures
according to the instructions included in the 10.1.2.
10.1.2.1. CONNECTING THE SOWING MACHINE TO A TRACTOR
- The tractor must be drawn up to the sowing machine so that the pivots of the
machine can be placed in the tractor hook slot then protect them with bolts. /Figure
10/. The tractor ramp must be raised in such a way that the lower tap pivots are in
front of the axes of the tractor hook.
- With the use of the tractor strands for raising and lowering the machine must be
placed in a vertical position. Mark the strands setting or install limiters.
- Connect the top point of the machine three-point system to a tractor with the use of
an adjusting screw the tractor is equipped with.
Figure 10
10.1.2.2. CONNECTING OF HYDRAULIC HOSES
.
Hydraulic oil is supplied to the marking gauge actuator.
Oil in the hydraulic system is under high pressure.
Before proceeding with connecting the hydraulic houses to a tractor, release the
excess pressure and switch off the tractor engine.
Adjusting
screw
Lower tap
