Ultratec SUPERPRINT 4425, Using Manual

Page: 80 / 98

Printer
The printer does not work.
Be sure the printer is on. If it is, try resetting the printer by turning the
Superprint 4425 off and on again.
Be sure the Printer setting in the Options is set to Printer(Internal). See
Changing to an external printer on p. 64 for more information.
The printer works, but it prints too lightly or not at
all.
Make sure you have high-grade thermal printer paper and it is correctly
installed. See Replacing the printer paper on page 74.
The printer only prints the bottom half of characters.
The print head should be replaced. Contact your dealer or Ultratec.
On battery power, the printer prints too slowly or
lightly.
The batteries are low. Connect the Superprint 4425 AC adapter for 24
hours to recharge the batteries.
Power
The flasher does not work.
Be sure the plastic tab has been pulled out of the battery compartment
and that you have plugged in the Superprint 4425 for at least 24 hours.
The batteries run down too soon.
You may not be regularly using your Superprint 4425 on battery power,
or the batteries are old. See
About the batteries on page 75.
The Superprint 4425 does not turn on when you press
the On/Off switch, or the power light blinks even when
the Superprint 4425 AC adapter is plugged in.
Be sure the electrical outlet is working. Be sure you are using the correct
AC adapter—it should be a 9VDC, 650 mA adapter. If you still have a
problem, contact your dealer or Ultratec.
7 8 • C A R E & R E PA I R