Ultratec SUPERPRINT 4425, Using Manual

Page: 48 / 98

Auto-answer options
Changing to a different auto-answer memo +
You can change to a different auto-answer memo by typing a new memo
name (and contents if necessary) when you turn on auto-answer. Follow
these steps to change your auto-answer memo:
1.
Press the auto-answer key ( + ). You will see ANSWER MEMO
and the name of your answer memo on the display.
2.
Type a new name and press the key.
3.
If the new memo does not already exist, type the contents of the
memo and press the
key. Auto-answer is on.
4.
If you do not want auto-answer on right away, press the key
again or turn off the Superprint 4425.
Note:
An auto-answer memo is the same as any other memo. It is saved
in memo memory and and you will see its name when you read through
the list of memos. See the Memo chapter on pages 51–56 for more
information about memos.
Setting the number of telephone rings +
You can set the Superprint 4425 so that it waits between 2 and 9 rings
before answering, or you can use the TS (Toll Saver) setting. The TS
setting tells the Superprint 4425 to answer after 2 rings if you have
messages or 5 rings if you do not. This saves the cost of a call when you
call from another TTY to read your messages, because you can hang up
after 3 rings. Follow these steps to change the number of rings:
1.
Press the options key ( + ).
2.
Press the key until the display says auto-answ RINGS (2). The
original setting is 2.
3.
Press the to choose a number between 2 and 9 or TS.
4.
Press the key to leave options.
Esc
Spacebar
Return
9 Ctrl
9 Ctrl
Esc
Esc
Return
+
=
Ctrl
+
=
Ctrl
4 6 • A U TO - A N S W E R