Ultrasonic UP3218, Operator And Maintenance Manual

Page: 155 / 272

Property of Ultrasonic Power Corporation -
© 2018
Publication #181114
155
5.2. MODEL 5300 GENERATOR
NOTE: Use the following procedure whenever the generator is not operating properly.
Do not attempt to do more than is listed below as it may void the warranty.
1. Remove power from the system.
2. Check fuses (on control panel and on back of
generator), replace if necessary.
3. Check for loose connection of wires.
4. Check supplied power for correct voltage
specifications.
5. Test generator by turning the system on.
6. If generator does not work, contact Ultrasonic Power Corporation service
department for repair or replacement.
NOTE: DO NOT open the generator as this will immediately void the warranty of the
generator.
5.3. VIBRA-BAR
®
TRANSDUCER PACK
1. Remove power from the system.
2. Check transducer stacks for damage and loose
wires.
3. If damage is visible or capacitance is low, contact
Ultrasonic Power Corporation service department for repair
or replacement.