Ultrasonic UP3218, Operator And Maintenance Manual

Page: 104 / 272

Property of Ultrasonic Power Corporation -
© 2018
Publication #181114
104
5.4. HEATERS
1. Remove power from the system.
2. Check heater fuses located on the inside of
the control panel.
3. Check heater pad for proper contact with the system tank.
4. Check for loose or damaged wires.
If damage is visible, contact Ultrasonic Power Corporation service department for repair
or replacement.
5.5. PUMP, FILTER & PRE-STRAINER
1. Remove power from the
system.
2. Check pump fuses
located on the inside of
the control panel.
Replace fuse as needed.
3. Turn both filter valves to "OFF" Position. Unscrew filter
housing located outside the machine. Replace filter.
Hand tighten filter back in place.
4. Remove access panel of machine.
5. Check for plumbing for leaks.
6. Inspect pump for damage and/or loose wires.
System Pump
Filter Housing