Ultrak JPD-101, User Manual

Page: 60 / 144

AUXILIARY CONTROL
518007-3960-F 2-42 KEMU040019
April 25, 2001
2.2.11 Auxiliary Contact Output Control (ON/OFF)
The controller can be used to turn auxiliary devices on or off. The CATS
Video Switcher (1-4), the CRX-800 Series Control Receivers (1-6) and the
AIF-100/CO Contact Output Units (1-8) all have contact outputs for
connection to VCR's, flood lights, etc. The CRX-800 Receivers and the AIF-
100/CO units are addressable. The contacts are controlled by sending an
ON message for a specific contact to the unit address or an OFF message
for a specific contact to the unit address. If the contact output is configured
as normally open, an ON message closes the contact and an OFF message
opens the contact. If the contact output is configured as normally closed, an
ON message opens the contact and an OFF message closes the contact.
To control a contact output, the primary control camera must be the address
of the unit where the contact output is located. To control the contact
outputs on the CATS Video Switcher, the primary control camera must
be camera 1. Note: Camera 1 cannot have a CRX-800 Receiver or an AIF-
100/CO Contact Output Device if a CATS Video Switcher is installed in the
system and the system requires control of the contact outputs.
ON COMMAND SEQUENCE
There are two command sequences to turn an auxiliary device on. Perform
one of the following command sequences.
1. Auxiliary #>AUX>1 # AUX 1
or