Ultrak JPD-101, User Manual

Page: 120 / 144

518007-3960-F 5-2 KEMU040019
April 25, 2001
Because this unit is just one part of an overall system, it may be necessary
to verify that the other equipment types have been installed and are
operating correctly before assuming the problem exists at the controller
unit. If problems still exist after verifying correct installation and the
problem has been isolated to the controller, then it must be removed for
servicing. THERE ARE NO USER-SERVICEABLE PARTS COMPRISING
THE SMART HAND CONTROLLER UNIT. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
c. Battery Replacement
The JPD-101 unit has a lithium battery located on the control board at
XU4A. The life expectancy of the battery is 10 years. If necessary, replace
the battery with a Dallas #DS1213C. This battery is also available through
Ultrak, part number 840301-0025. Use of another battery may present a
Risk of Fire or Explosion.
CAUTION
Battery May Explode If Mistreated. Do Not
Recharge, Disassemble Or Dispose Of In
Fire.
WARNING
REMOVE POWER TO THE UNIT PRIOR TO
REMOVING THE COVER. THERE IS HIGH
VOLTAGE PRESENT ON THE CIRCUIT
BOARD. REFER TO THE FOLLOWING
FIGURE FOR LOCATION OF HIGH
VOLTAGE.
To replace the battery, remove the bottom cover from the controller by removing
the eight (8) screws on the bottom cover.